PSDW-780
4. SETUP
5. OPERATE
1. Ensure the distance from the lowest to the highest point that you
wish to distribute the water does not exceed 8 metres
2. Ensure that the container is large enough to allow the float
switch to move freely and function effectively, A minimum of
area of 50x50x50cm is required.
CAUTION:
NEVER CARRY, LIFT OR PULL UP THE
PUMP BY THE POWER CORD. THIS WILL DAMAGE
THE UNIT.
IMPORTANT:
BEFORE SUBMERGING THE PUMP IN
WATER, UNWRAP THE POWER CABLE AND ENSURE
THE PLUG IS CLEAR OF ANY DAMP LOCATIONS.
CAUTION:
THIS PRODUCT IS INTENDED FOR
PUMPING WATER IN A HOME DOMESTIC
APPLICATION. DO NOT USE IT FOR CORROSIVE,
ABRASIVE, EXPLOSIVE OR DANGEROUS LIQUIDS.
CAUTION:
YOUR PUMP HAS THE CAPACITY
TO PUMP DIRTY WATER WITH A NON SOLID
PARTICLE SIZE OF UP TO 35MM IN DIAMETER.
MIN. 50x50CM
MAX. IMMERSION
7 METRES
MAX. HEAD 8 METRES
3. Ensure the pump is placed on a flat and level surface, there are no
obstructions to the suction base and out of mud or sediment.
1. Immerse the pump in the
water. For deep water, use
a rope (not included) and
secure it to the handle. Set
the pump in the desired
position within the work area
or tank.
2. Insert the plug into the
mains power socket.
Where possible avoid using
extension cords as this can
lead to a voltage drop which
may cause power loss and
overheating. Switch on the
mains power to operate
pump.
3. To stop operation, turn off the mains power. The pump will also
stop operation automatically once the float switch reaches the
minimum water depth (50mm).
Priming
When immersed and ON the pump will need to prime and purge
the air inside the pump before water flows at the outlet. This can
take up to 20 seconds. If operating the pump manually tilting the
pump to allow some air to escape from the base can help.
Air also escapes from the Air Bleed
Valve. When pumping, the water
pressure will shut this valve off.
WARNING!
THIS PUMP MUST BE USED WITH RESIDUAL
CURRENT DEVICE RATED 30mA OR LESS.
