WARNING! Before attempting any of the following operations, make
sure that the tool is switched off and unplugged and that the spindle
has stopped.
Installing the handles
1. Insert the Phillip heads screws/washer provided through the hole in the handle (4).
2. Align the handle (4) with the square cut fixing on the left and right sides of the
Router (Fig. 1).
3. Tighten the screws clockwise with a Phillips head screwdriver (Fig. 2).
4. Using the cover buttons provided fix into the holes to cover the screw (Fig. 3).
Fitting a Router Bit
Caution: Please DEPRESS spindle lock lever.
Pulling the spindle lock lever may break the lever.
Note: When changing accessories on the router it is
advisable to lay the router on a flat surface.
1. Depress the spindle lock lever (8) and use the
spanner (14) provided to loosen the collet nut (9) in
an anti clockwise direction. Keep the spring (21)
and collet in the spindle (Fig. 4).
2. Insert the shank of the router bit into the collet (22).
Ensuring the shaft of the router bit is inserted all
the way into the collet. Raising the router bit
approximately 2mm (Fig. 5).
3. Fasten the collet nut (9) using the spindle lock
lever (8) and spanner (14). Depress the spindle
lock lever (8) and tighten the collet nut (9) with the
spanner in a clockwise direction. This will secure the
collet (22) and router bit.
Caution:
Do not over tighten. Ensure you remove the spanner then plug the tool
in and turn it on. Check for any undue vibration or wobbling which may indicate
the bit is damaged or not installed correctly.
OPERATION
8
Fig. 1
Fig. 2
Fig. 3
!!
Fig. 4
Fig. 5
Summary of Contents for PRR-850
Page 1: ......
