OPERATION
Adjusting The Base Plate for Bevel Cuts
1. Remove the dust extraction adaptor if it is in place.
2. Use a hex key to loosen (but not
fully remove) the two bolts on the
underside of the tool.
3. Rotate the base plate until the
desired bevel angle is achieved.
There are angle measurements
marked on the outer ring of the
base plate channel as a guide.
Note:
Ensure the teeth are
securely engaged against the
stopper.
4. Re-tighten the bolts to lock the base plate in place.
Adjusting The Pendulum Cutting Setting
The pendulum cutting feature on the tool allows the blade to cut faster and
more efficiently through thicker and/or softer materials. A rough guide on
choosing the correct setting is provided in the table below.
1. To increase the pendulum cutting
action, rotate the pendulum
setting lever anti-clockwise.
2. To decrease the pendulum cutting action, rotate the lever clockwise to a
lower setting.
1 -
No Pendulum Action
for fine clean cuts on thin or hard materials
2 -
Small Pendulum Action
for faster cutting on hard materials
3 -
Medium Pendulum Action
for faster cutting on softer materials
4 -
Large Pendulum Action
for fast cutting along the grain on soft materials.
PXCJS-018
4. CONTROLS
0
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
WARNING!
FAILURE TO SECURE THE BASE PLATE
ACCORDING TO THESE INSTRUCTIONS MAY LEAD
TO SERIOUS INJURY.
WARNING!
DO NOT USE THE SPLINTER GUARD
WHEN MAKING BEVEL CUTS WITH THE TOOL.
