Installing A Blade
1. Flip the blade guard out of the
way.
2. While holding the tool upside
down, press and hold the tab on
the blade lock clockwise.
3. With the blade teeth
facing towards the front
of the tool, fully insert the
blade into the lock.
Note:
Ensure that the
blade is sitting in between
the guide rollers.
4. Release the blade lock and pull on the blade to ensure it is fully secured.
5. Flip the blade guard back into place before use.
Removing The Blade
1. Flip the blade guard out of the
way.
2. While holding the tool upside
down, press and hold the tab on
the blade lock clockwise.
3. Pull the blade out of the blade
lock to remove it.
4. Flip the blade guard back into place before use.
Using The Dust Extraction Adaptor
The dust extraction adaptor can be used to connect a vacuum to the tool.
This will allow you to remove dust and material chips while cutting. It can
also be removed if it gets in the way.
1. Install the dust extraction adaptor
by pushing it into the channel on
the back of the base plate.
2. A Ø36mm vacuum hose can then
be attached to the free end of the
adaptor.
3. To remove the adaptor, simply pull it free of the channels on the base
plate of the tool.
3. FITTING THE BLADE
a.
b.
WARNING!
ENSURE THE TOOL IS SWITCHED
OFF AND THE BATTERY IS REMOVED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.