1
ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
Handle
Upper &
Lower Shaft
Safety Guard
Cutting Blade
Spool
Screwdriver
Support Plate
Harness
Spark Plug
Wrench
Spanner
4 & 5mm Hex Key
Screw (2x)
Split Pin (2x)
Engine Oil
Filling Bottle
14
19
18
17
10
11
12
13
1
5
6
2
3
4
8
9
7
ACCESSORIES
21 4 & 5mm Hex keys
22 Spark plug wrench
23 Screwdriver
24 Spanner
25 Filling bottle
26 Screw (x 2)
27 Split pin
1 Choke lever
2 Recoil starter
3 Air filter housing
4 Fuel pump “primer”
5 Petrol tank
6 Support plate
7 Rear handle
8 Throttle lever lock-out
9 Throttle lever
10 Ignition switch
11 Forward handle
12 Upper shaft
13 Shaft connecting piece
14 Dip stick
15 Lower shaft
16 Harness
17 Safety guard
18 Spool and line
19 Knife edge
20 Brush cutting blade
Fitting the
forward handle
1. Using the 4mm hex key,
unscrew the four screws on
the forward handle.
2. Position the foward handle
on the uppershaft and
tighten the four screws.
Fitting the lower
shaft
1. Loosen and remove the handle
screw on the upper shaft
connecting piece.
3. Ensure that the lug of the locking
lever latches into the hole in the
lower shaft, you may need to
turn the lower shaft
slightly to enable correct fitting.
Fitting the support plate
The support plate needs to be
installed on to the underside of the
motor, in front of the fuel tank. To
do so, turn the unit upside down
and fix the support plate in position
using the two supplied screws and
screwdriver.
KNOW YOUR PRODUCT
ASSEMBLY
1. ASSEMBLING THE TRIMMER
PETROL LINE TRIMMER / BRUSH CUTTER
WARNING!
DO NOT START THE ENGINE UNTIL
THE LINE TRIMMER/BRUSH CUTTER IS FULLY
ASSEMBLED.
2. Pull the locking lever and push
the lower shaft carefully into the
shaft connecting piece.
4. Tighten the handle screw.
16
20
15
27
21 22 23 24 25 26
