8
It is recommended that the Multi-function Sharpener be bolted to a secure bench
prior to operating.
Chisel and blade sharpener
1. Install chisel and blade sharpener module (2) by
sliding it onto the power unit (8).
2. Position the chisel or blade on the blade rest (2e).
The magnets (2b) will hold the blade in position.
(See Fig. 1)
3. Ensure the sharpening angle matches the existing
beveled angle on the chisel or blade.
4. To change the angle, loosen adjustable angle knob (2d). Select the angle
required and tighten the adjustable angle knob (2d).
5. Ensure the blade edge touches the sharpening wheel. Switch on the power
unit (8) by pushing the switch (1) to the “ON” position.
6. Slide the blade rest (2e) and blade back and forth across the sharpening
wheel (3) with light, steady pressure in a continuous motion. DO NOT hold the
blade stationary at any time to avoid damage to the blade.
7. Gradually adjust the blade down the blade rest (2d) while sharpening.
8. When sharpening narrow chisel blades, place the narrow chisel guide onto the
blade rest (2d) to act as a spacer and sharpen as above.
9. Switch off the power unit (8) after sharpening. Ensure sharpening wheel (3) has
stopped before changing modules.
10. It is recommended that the blade tip is honed on a sharpening stone after grinding.
Drill bit sharpener
1. Install drill bit sharpener module (4) by sliding it
onto the power unit (8) (Fig. 2).
2. Remove the clamp
assembly (4b) and insert
a drill bit to be sharpened
(Fig. 2). Tighten the
clamp assembly (4b)
lightly (Fig. 4) so that the
drill bit can still move.
TOOL OPERATION
Fig. 1
Fig. 2
Fig. 3
Fig. 4