1 Make a loop with the
extension cord and push it
through the hole under the
on/off trigger.
1 Turn the trimmer upside
down and place the safety
guard over the cutting
head.
3 Align the edging wheel with
the screw holes at the front
of the safety guard.
2 Place the loop onto the
cord retainer and ensure it
is pulled firmly into place.
2 Rotate the guard into the
correct position and secure
with the supplied screw.
4 Secure the edging wheel
with the remaining supplied
screws.
2. GUARD AND CORD RETAINER
3. HANDLE AND CUTTER HEAD ANGLE
Fitting the Safety Guard
WARNING!
NEVER USE THE LINE TRIMMER UNLESS THE
SAFETY GUARD IS PROPERLY FITTED AND SECURED.
NOTE:
TO AVOID THE EXTENSION CORD FROM DETACHING;
ALWAYS CHECK THAT THE CORD IS ATTACHED TO THE CORD
RETAINER BEFORE USE.
Using the Cord Retainer
1 Place the adjustable
handle onto the line
trimmer so that the holes
align.
1 Depress the adjustable
head lock button on both
sides of the motor housing.
1 Depress the lock button on
the main handle.
3 Rotate the handle into the
most comfortable position
and tighten the locking
knob.
2 Pass the bolt through the
handle and screw the
locking knob loosely onto
bolt.
2 Move the telescopic handle
into the desired position
and release the head lock
button.
2 Rotate the main handle
into the desired position
and release the lock
button.
Fitting the Secondary Handle
Adjusting the Cutter Head Angle
Adjusting the Main Handle Position