MAINTENANCE
DESCRIPTION OF SYMBOLS
CARING FOR THE ENVIRONMENT
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• Keep ventilation slots of the trimmer clean at all times. Periodically clean
out the grass from the cutting head and the rim of the safety guard to ensure
efficient operation at all times.
• After each use, blow air through the tool housing to ensure it is free from all
dust, dirt, etc. Build up of dust, dirt particles may cause the tool to overheat and
shorten the life of the tool.
• If the housing of the trimmer requires cleaning, do not use solvents but a
moist soft cloth or soft brush only.
• Never let any liquid get inside the tool, never immerse any part of the tool into
liquid.
• No lubrication is necessary as the tool has sealed bearings.
• When not in use, the line trimmer should be stored in a dry, frost free location
not within the reach of children.
Note: Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the line trimmer by an unauthorised person or by mishandling
of the line trimmer. This tool is designed for DIY use - use in commercial or
industrial environments will void the warranty.
Spool & Line
ACCLT-005
Spool Cover(Pack 2)
SPOZLT550-30
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
V
Volts
Hz
~
Alternating current
W
/min
Revolutions or
reciprocation per minute
Double insulated
n
o
Warning
Wear eye & hearing
protection
Regulator compliance mark
Read instruction manual
Keep bystanders away
Disconnect the mains plug
if the cord is damaged
or entangled
Decibel level
Do not operate in the rain
Keep bystanders away
Hertz
Watts
No load speed
96
dB
Problem
Cause
Remedy
Grass wraps
around the
attachment shaft
and the trimmer
head.
Cutting tall grass
at ground level.
Make several passes from
top down.
1 While holding the tabs on
either side of the spool,
remove the spool cover.
1 Feed 3cm of 1.6 mm cutting
line into the hole in each
section of the spool.
3 Insert the rewound spool and
rotate until it is seated.
5 Push the cover onto the
housing until it snaps into
place.
Note:
If the cutting lines
protrude beyond the trimming
blade, cut them off so that they
just reach the blade.
2 Remove the empty spool from
the housing and any dirt or
grass.
2 Wind the 2 lines neatly onto
each section of the spool in
the direction of the arrows on
the spool.
4 Unclip the ends of the cutting
lines and guide them through
the eyelets so that the line
protrudes approx. 11cm.
Replacing the Spool and Line Assembly
Winding New Line Onto Empty Spool
WARNING!
ENSURE THE TOOL IS DISCONNECTED FROM
THE POWER SUPPLY BEFORE PERFORMING ANY OF THE
FOLLOWING OPERATIONS.