DESCRIPTION OF SYMBOLS
Cleaning
1. We recommend that you clean the appliance immediately after
you use it.
2. Keep the safety devices free of dirt and dust as much as
possible. Wipe the equipment with a clean cloth.
3. Clean the appliance regularly with a damp cloth and some soft
soap. Do not use cleaning agents or solvents; these may be
aggressive to the plastic parts in the appliance. Ensure that no
water can get into the interior of the appliance.
Lubrication
1. Regularly remove shavings from the depth setting chains,
reduction drive and lifting screws for the blade holder.
2. Remove chips with a cloth and brush, then lightly grease with a
clean brush dipped in oil.
WARNING!
NEVER POUR OIL DIRECTLY ON THE
COMPONENTS. TOO MUCH OIL WILL CAUSE DUST TO
STICK AND IMPAIR LUBRICATIONS, WHICH IN TURN
REDUCES THE SERVICE LIFE OF THE MACHINE.
WARNING!
THE BLADE HOLDER BEARINGS ARE
SEALED AND MUST NOT BE LUBRICATED.
Carbon Brushes
When the carbon brush wears out, the tool will spark
and/or stop. Discontinue use as soon as this happens. It
should be replaced prior to recommencing use of the tool.
Carbon brushes are a wearing component of the tool, and
are not covered under warranty. Continuing to use the tool when
the carbon brush needs to be replaced may cause permanent
damage to the tool. Carbon brushes will wear out after many uses
but when the carbon brush needs to be replaced, take the tool to
an electrician or a power tool repairer for a quick and low cost
replacement.
Storage
Pull the mains plug out of the socket, switch off the tool and make
sure that it is secured in such a way that it cannot be started up
again by any unauthorised person.
Store the tool in a dry location which is not accessible to
unauthorised persons.
Supply Cords
If replacement of the supply cord is necessary, this has to be done
by a certified electrician in order to avoid a safety hazard.
Note:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the tool by an unauthorised person
or by mishandling of the tool.
Meters per minute
Millimetres
Wear gloves
Keep bystanders away
Switch off & remove plug from
mains before adjusting, cleaning or
if the cord is entangled or damaged
Beware of debris being ejected
from the machine
Rotating blades; keep hands & feet
out of openings while the machine
is running
Warning
Regulatory Compliance Mark
(RCM)
Sound power level in decibels
Double insulated
Wear eye, ear & breathing
protection
Sharp blade; keep hands clear
V
Volts
Hz
W
Hertz
~
n
0
mm
/min
m/min
Alternating Current
Watts
No load speed
Revolutions per minute
Read Instruction Manual
L
WA
Power tools that are no longer usable should not
be disposed of with household waste but in an
environmentally friendly way. Please recycle where
facilities exist. Check with your local council authority for
recycling advice.
Recycling packaging reduces the need for landfill and raw
materials. Reuse of recycled material decreases pollution
in the environment. Please recycle packaging where
facilities exist. Check with your local council authority for
recycling advice.
CARING FOR THE ENVIRONMENT
SPARE PARTS
Spare parts can be ordered from the Special Orders Desk at your
local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
