Trimming
1. Before inserting the battery, extend
the edging guide to prevent the
cutting head from getting too close
to an object such as a tree trunk or
wall.
2. Hold the grass trimmer by the rear
handle and the adjustable handle
for best control and balance.
Weight should be balanced with
both feet on solid ground.
3. Start the grass trimmer before
approaching the grass to be cut.
Note:
The best results will be achieve
by cutting dry grass.
4. Stand with the cutting head tipped down at an angle in front,
guiding the line trimmer in a semi-circular motion around you.
5. When cutting long grass, cut in stages from the top of the grass to
the bottom of the grass.
6. Use only the tip of the cutting blade to do the trimming especially
near walls and fences. Trimming with the side of the cutting blade
may overload the motor, wear out the blades faster, and break the
blades more often.
Note:
If the motor starts to slow down, reduce the cutting load.
7. If then grass trimmer is not cutting correctly, the blades will need to
be replaced, refer to the maintenace section of this manual.
8. After finishing the cutting operation, keep the head close to ground
level, release the trigger switch and allow the motor to come to
a complete standstill. Place the line trimmer on the ground, and
remove the battery.
Edging
Place the edging guide along
the ground and slide the grass
trimmer along the edge of the
path.
OBLTHTC - 018
4. TRIMMING & EDGING
WARNING!:
INSPECT THE AREA TO BE TRIMMED
AND REMOVE ANY WIRE, CORD OR STRING-LIKE
OBJECTS WHICH COULD BECOME ENTANGLED IN
THE ROTATING BLADE HOLDER.
CAUTION!:
BYSTANDERS MUST KEEP A MINIMUM SAFE
DISTANCE OF 10M AWAY FROM THE GRASS TRIMMER
WHILE IT IS OPERATING.
Adjusting the height
The Telescopic Shaft can be adjusted
to suit different user heights.
1. Grip the shaft Adjustment Lock
firmly and turn clockwise to unlock
the shaft.
2. Adust the length of the Telescopic
Shaft to the most comfortable
position.
3. Turn the shaft Adjustment Lock anti-clockwise to lock the shaft in
position.
Tilting the cutter head
The Cutter Head can be adjusted to
differt andles for ease of cutting in
different conditions.
1. While firmly holding the Telescopic
Shaft in one hand, push and hold
the Adjustment Button.
2. Tilt the Cutter Head to the desired
angle (1, 2, 3, 4) and release the Adjustment Button.
Rotating the cutter head
The cutter head can be rotated for
ease of trimming and edge cutting in
different conditions.
1. Whilst firmly holding the Telescopic
Shaft in one hand, pull back on the
Rotating Shaft Release.
2. Rotate the Telescopic Shaft 180° clockwise.
3. Release the Roating Shaft to secure in position.
Note:
To return the Cutter Head rotate 180° anti-clockwise in step 2.