The MIG welder can be fitted with 0.8mm or 0.9mm gasless welding
wire. Welding wire up to 0.4kg can be fitted to this welder.
2. FITTING THE WELDING WIRE COIL
4. WIRE DRIVE ROLLER SIZE
WARNING:
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING STEPS.
2 Rotate the roller locking dial
anti-clockwise and lift off.
4 Secure the wire drive roller
by fitting the roller locking dial
and rotating it clockwise.
2 Remove the wing nut by
rotating anti-clockwise and
remove the drive washer.
4 Align the drive washer lug
with the slot in the drive shaft
and secure with the wing nut
by rotating clockwise.
There are two sizes on the roller included with the MIG welder; one side
of the roller suits 0.8mm gasless flux-cored welding wire and the other
suits 0.9mm gasless flux-cored welding wire.
1 Rotate the locking arm
up and then swing the
pressure arm away from
the guide roller.
3 Lift the wire drive roller
off the shaft and inspect
it to confirm the wire
groove size stamped on
either face. Ensure the
wire drive roller size you
require is facing upwards
when assembled.
3 Slide the welding wire
coil onto the shaft.
Ensure the unwound
end of the welding
wire is on the closest
side to the wire guide.
1 Open the top cover
by rotating the locking
knob and then lifting
the panel.
a
b
a
b
CAUTION:
IT IS CRITICAL THAT YOU CHOOSE THE
CORRECT WIRE DRIVE ROLLER SIZE.
