ONLINE MANUAL
Scan this QR Code with your
mobile device to take you to
the online manual.
MIG WELDER
ACCESSORIES
1 On/Off Switch
2 Overload Protection LED
3 Wire Feed Speed
4 Carry Handle
5 Side Cover
6 Internal Cooling Fan
7 Welder Gas Intake Barb
8 Output Voltage Control Dial
9 Side Cover Release Lever
10 Earth Clamp
11 Torch Tip
12 Shroud
13 MIG Torch
14 Welding Mask
15 Chipping Hammer / Wire
Brush
16 Terminal Spanner
KNOW YOUR PRODUCT
1. TERMINAL CONFIGURATION
SETUP & PREPARATION
1 2 3 4 5 6 7
8
9
10
11
14 15 16
12 13
WARNING:
ENSURE THE TOOL IS SWITCHED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING STEPS.
1 Open the side cover by
raising the side cover
release lever.
3 Ensure that the terminals
are secure by tightening
the terminal knobs using
the terminal spanner.
2 Connect the positive
welding cable (red) to the
negative terminal and the
negative welding cable
(black) to the positive
terminal.
2 Connect the positive
welding cable (red) to the
positive terminal and the
negative welding cable
(black) to the negative
terminal.
Setting the Welding Current for Gasless or Gas Shielded
Gasless Welding Mode
Gas Shielded Welding Mode
WARNING:
TERMINAL KNOBS MUST BE SECURELY
TIGHTENED PRIOR TO OPERATION. LOOSE OR
INCORRECT FASTENING MAY CAUSE THE CONNECTION
TO OVERHEAT OR BURN.
