10
OPERATION (cont.)
Sawing – Round Blade
CAUTION: Clamp your workpiece securely if possible before commencing your work.
NOTE: Ensure your blades are not blunt or damaged in any way before
commencing your application.
1. In sawing mode the Multi Function Tool can be used on wood, plastics and
sheet metal.
2. Slide the on/off switch (2) forward to the “on”
position. Ensure it is not placed on the workpiece.
3. Select the desired oscillating frequency speed on the
variable speed dial (1) and wait until the motor
reaches its maximum speed
4. If plunging use a slight pendulum motion, to allow
sufficient chip or debris removal (Fig. 8).
NOTE: If using the Multi Function Tool for plunge cuts. Only use this application
on soft materials such as wood, gypsum plaster boards. Also check if there are
no nails or screws in the workpiece before cutting.
Sawing – Square Blade
CAUTION: Clamp your workpiece securely if possible
before commencing your work.
NOTE: Ensure your blades are not blunt or damaged
in any way before commencing your application.
1. In sawing mode, the Multi Function Tool can be used
on wood, plastics and sheet metal.
2. Slide the on/off switch (2) forward to the “on”
position. Ensure it is not placed on the workpiece.
3. Select the desired oscillation frequency speed on the
variable speed dial (1) and wait until the motor
reaches its maximum speed
4. If plunging use a slight pendulum motion, to allow
sufficient chip or debris removal (Fig. 9).
NOTE: If using the Multi Function Tool for plunge cuts. Only use this application
on soft materials such as wood, gypsum plaster boards. Also check if there are
no nails or screws in the workpiece before cutting.
Fig. 8
Fig. 9
MFR-250 manual.qxd 1/12/11 11:24 AM Page 11
Summary of Contents for MFR-250
Page 1: ......