9
Fig. 6
OPERATION
Preparing The Lawn Edger For Use
Telescopic Shaft Adjustment
The lawn edger can be adjusted to suit the height of the operator.
1. Loosen the telescopic locking collar (5) by rotating in a anti-clockwise direction.
2. Adjust the telescopic shaft up or down to the appropriate height. Tighten the
telescopic locking collar (5).
Cutting Depth
The lawn edger provides 3 cutting depths, 15, 25 and 38mm.
1. Loosen the depth adjustment locking knob (8) to
allow you to push the knob enough to move the
guide wheel arm across to the opposite side of
the housing (Fig 4).
2. Raise the guide wheel cutting arm to increase
the depth or lower to decrease the depth. Firmly
tighten the depth adjudstment locking knob (8)
when the guide wheel arm has located into the
desired cutting depth (Fig. 5).
Note:
Ensure the lug on the guide wheel arm is
correctly located into the preset depth position on the
motor housing.
Extension Cord Retainer (Fig. 6)
To avoid detaching the extension cord always check
that it is attached to the cord retainer before using the
lawn edger.
1. Make a loop with the extension cord and push it
through the square hole beneath the handle.
2. Place the end of the loop around the cord retainer
and ensure it is pulled firmly enough to prevent it
from coming loose whilst operating the lawn edger.
3. Connect the extension cord socket to lawn edger cord plug.
WARNING!
The lawn edger runs for a few seconds after the switch has
been released. Let the motor come to a complete standstill before setting
the tool down.
Fig. 4
Fig. 5