1. Loosen the Telescopic
Shaft Collar by rotating in
a clockwise direction.
1. Turn the trimmer upside
down and place the safety
guard over the cutting
head.
3. Align the edging wheel
with the screw holes at
the underside front of the
safety guard and secure
with the remaining supplied
screws.
2. Adjust the Telescopic
Shaft up or down to the
appropriate height.
2. Rotate the guard into the
correct position and secure
with the supplied screws.
2. ASSEMBLY
3. ADJUSTMENTS
SETUP & PREPARATION
Adjusting the Working Height
Fitting the Safety Guard
WARNING!
ENSURE THE TOOL IS DISCONNECTED FROM
THE POWER SUPPLY BEFORE PERFORMING ANY OF THE
FOLLOWING OPERATIONS.
WARNING!
NEVER USE THE LINE TRIMMER UNLESS THE
SAFETY GUARD IS PROPERLY FITTED AND SECURED.
1. Place the adjustable
handle onto the line
trimmer so that the holes
align.
1. Depress the Head Angle
Release Button.
3. Rotate the handle into the
most comfortable position
and tighten the locking
knob.
2. Pass the bolt through the
handle and screw the
locking knob loosely onto
bolt.
2. Move the Telescopic Shaft
into the desired position
and release the Button.
Fitting the Secondary Handle
Adjusting the Cutter Head Angle
3. Tighten the Telescopic Shaft Collar once adjustment is
complete.
Rotating the Cutting Head
1. Pull the Rotating Head
Collar and turn the
Telescopic shaft 180º ant-
clockwise.
Note:
The head will only
rotate in one direction.
2. Release the Collar to lock
in place.
