2. CONTROLS
3. DIGITAL DISPLAY
OPERATION
Reference Point Icon
Switching On and Off
Measuring Button
Changing Operating Modes
Operating Mode Icon
Battery Charge Indicator
Measurement Value
Changing the Reference Point
1 To turn the unit on, press the
on/off Button
Once the unit is turned on, the
on/off & measuring button can
be pressed once to display the
laser pointer to align, then should
be pressed again to take the
measurement.
1 Press the mode & reference
button to cycle through the
numerous operating modes
until the desired mode is
selected.
1 The icon to the right of the
reference icon will indicate the
current operating mode:
• Single distance
• Area
• Volume
• Continuous Minimum
• Continuous Maximum
1 The icon at the top right corner
indicates the charge level of
the batteries.
1 Once a measurement is taken,
the distance will show on the
digital display.
Note:
The current and previous
measurements are both displayed
on screen.
1 Press and hold the mode &
reference button down until
the reference point changes.
The reference point is where the measurement is measured from. You
can measure from the top or bottom of the laser unit.
2 To turn the unit off, hold the
on/off button down until the
unit turns off.
OFF
m
Min/Max
OFF
m
Min/Max
OFF
m
Min/Max
OFF
m
Min/Max
MIN
MAX
OFF
m
Min/Max
MIN
MAX
OFF
m
Min/Max
OFF
m
Min/Max
HOLD
OFF
m
Min/Max
HOLD
OFF
m
Min/Max
OFF
m
Min/Max
1 When using the
Bottom
of the laser as the
reference point, the icon shown here will be
displayed in the top left corner.
Note:
The height of the tool will be included
in the measurement.
2 When using the
Top
of the laser as the
reference point, the icon shown here will be
displayed in the top left corner.
Note:
The height of the tool will not be
included in the measurement.
WARNING!
ENSURE LASER WINDOW IS NOT AT
EYE LEVEL OR DIRECTED TOWARDS OTHERS
WHEN OPERATING.
These modes are explained in the ‘Operating Modes’ section.
