2. USING THE TRIPOD
3. ADJUSTING THE TRIPOD
Attaching the Laser to the Tripod
The tripod allows you to set up the laser in a specific position and easily
make adjustments to the height, angle and tilt of the unit.
1 Open up the 3 legs of the
tripod to stabilise the platform.
2 Align the 1/4” mount
at the base of the
laser unit with the 1/4”
screw at the top of the
tripod.
3 Rotate the laser unit clockwise
to fasten the unit to the
mounting plate securely.
Note:
Make sure the laser is
pointing perpendicular to
the angle adjusting handle.
a
b
4 To remove the laser unit
from the mounting plate,
rotate the unit anti-
clockwise.
Rotating the Laser
1 Loosen the rotation locking
knob by rotating anti-
clockwise. Adjust unit by using
the angle adjusting handle.
Note:
Secure in place after
adjusting, by turning the
rotation locking knob
clockwise.
Adjusting the Height of the Laser
Adjusting the Angle of the Laser
Adjusting the Tilt of the Laser
a
b
a
b
1 Extend the 3 legs of the tripod
by unlocking the leg locking
levers and raising the legs.
Note:
Ensure the locking levers
are locked once desired
height is achieved to
secure the tripod.
2 To raise the laser further, wind
the height locking knob anti-
clockwise to loosen, then raise
the laser by winding the height
adjustment handle.
Note:
Ensure the height locking
knob is secured after
adjusting, by rotating
clockwise.
1 Rotate the angle
adjusting handle anti-
clockwise to allow the
handle to move.
2 Adjust unit to the desired
angle using the handle, then
secure in place by rotating the
handle clockwise.
1 Loosen the tilt locking knob by
rotating anti-clockwise. Then
adjust the tilt angle and secure
in place again.
