2. USING THE TRIPOD
3. ADJUSTING THE TRIPOD
Adjusting the Height of the Laser
Attaching the Laser to the Tripod
Adjusting the Angle of the Laser
Adjusting the Tilt of the Laser
The tripod allows you to set up the laser in a specific position and easily
make adjustments to the height, angle and tilt of the unit.
1 Open up the 3 legs of the
tripod to stabilise the platform.
2 Align the 1/4” mount
at the base of the
laser unit with the 1/4”
screw at the top of the
tripod.
3 Rotate the laser unit clockwise
to fasten the unit to the
mounting plate securely.
Note:
Make sure the laser is
pointing perpendicular to
the angle adjusting handle.
a
b
a
b
a
b
4 To remove the laser unit
from the mounting plate,
rotate the unit anti-
clockwise.
1 Extend the 3 legs of the tripod
by unlocking the leg locking
levers and raising the legs.
Note:
Ensure the locking levers
are locked once desired
height is achieved to
secure the tripod.
2 To raise the laser further, wind
the height locking knob anti-
clockwise to loosen, then raise
the laser by winding the height
adjustment handle.
Note:
Ensure the height locking
knob is secured after
adjusting, by rotating
clockwise.
1 Rotate the angle
adjusting handle anti-
clockwise to allow the
handle to move.
2 Adjust unit to the desired
angle using the handle, then
secure in place by rotating the
handle clockwise.
1 Loosen the tilt locking knob by
rotating anti-clockwise. Then
adjust the tilt angle and secure
in place again.
Rotating the Laser
1 Loosen the rotation locking
knob by rotating anti-
clockwise. Adjust unit by using
the angle adjusting handle.
Note:
Secure in place after
adjusting, by turning the
rotation locking knob
clockwise.
