Ozito Industries will not be responsible for any damage or injuries
caused by repair of the tool by an unauthorised person or mishandling
or mistreatment of the tool. This tool is designed for Domestic Home Use
only. Use in commercial or industrial environments will void the warranty.
CAUTION!:
ALWAYS HANDLE THE ROLLER WITH CARE
– SHARP EDGES COULD CAUSE SERIOUS INJURY.
USE GLOVES.
MAINTENANCE
WARNING!:
BEFORE CLEANING OR CARRYING
OUT ANY MAINTENANCE PROCEDURE, MAKE
SURE THAT THE MOTOR IS OFF AND THE TOOL
DISCONNECTED FROM THE POWER SUPPLY TO
PREVENT ACCIDENTAL STARTING.
Removing the Roller
1. With a 5mm hex key (not included),
remove the two bolts.
2
1
Square Drive
Holder
1
2
Fitting the Roller
•
Keep all nuts, bolts and screws tight to be sure the scarifier aerator is in a
safe working condition.
• Check the catcher frequently for wear or deterioration.
• Replace worn or damaged parts for safety.
•
Only use the replacement roller specified for this product.
•
Be careful during adjustments of the scarifier aerator to prevent entrapment
of the fingers between moving roller and fixed parts of the machine.
• Oil the wheel pins.
• When not in use, the
scarifier aerator should be stored in a dry, frost-free
location, out of reach of children. If the housing requires cleaning, do not use
solvents but a moist soft cloth and brush only.
•
Frequently check the roller bolt threads are firm and tight.
CAUTION!:
DO NOT TOUCH ROTATING ROLLER.
SERVICE INFORMATION
Please note that the following parts of this product are subject to normal
or natural wear and that the following parts are therefore also required
for use as consumables.
* Not necessarily included in the scope of delivery!
Category
Example
Wear parts*
V-belt, Roller
Consumables*
Missing parts
Only replace the roller with a genuine Ozito replacement roller, as this will
ensure top performance and safety under all conditions.
TROUBLESHOOTING
Problem
Cause
Remedy
The motor
fails to start
There is no electricity at
the plug
Check the cable and the
fuse
The cable is defective
Check the cable
Switch, switch/plug
block defective
Have machine checked by a
customer service centre
Connections to
motor or capacitor
disconnected
Have machine checked by a
customer service centre
Housing clogged
If necessary adjust working
depth. Clean housing so that
the roller can run freely
The motor
performance
drops
Soil is too firm
Change working depth
Housing clogged
Clean housing
Roller badly worn
Replace roller
Imprecise
scarifying
Roller worn
Replace roller
Wrong working depth
Correct working depth
Motor is
running, roller
is not rotating
Toothed belt is torn
Replace belt
2
1
Square Drive
Holder
1
2
2. Lift the roller on this side (1) and pull
out in the direction of the arrow (2).
1. Slide the new roller in the direction of the arrow (1) onto the square-ended
drive and press into the holder (2).
2
1
Square Drive
Holder
1
2
2
1
Square Drive
Holder
1
2
2. Refasten the roller with the two bolts using a 5mm hex key.
Note:
Apply grease to the square drive from time to time so that the rollers can
be changed easily.
