SETUP & PREPARATION
2. ASSEMBLY
WARNING!:
ENSURE THE TOOL IS DISCONNECTED
FROM THE POWER SUPPLY BEFORE ASSEMBLY
.
Fitting the Lower Handles to Motor Body
1. Inset the lower handle onto the
housing.
1. Place the middle handle inside
the upper ends of the lower
handles. From the handle
securing set, fit the bolts
through the outer side of the
lower handle and then through
the hole in the middle handle.
1. Secure the power cord from the
switch housing to the scarifier
aerator using the two cable clips
(supplied).
2. Pull the catcher over the catcher
frame.
1. Push both frame parts into
each other.
Securing the Power Cord to the Handles
Assembling the Grass Catcher
Fitting and Removing Grass Catcher
Fitting the Middle Handle to the Lower Handles
3. To empty the catcher, lift the
catcher flap with one hand,while
unhooking the catcher with the
other.
1. Lift up the catcher flap with
one hand and hook it onto the
housing from above.
2. Lower the catcher flap. The
catcher flap is held against the
catcher by a spring.
2. Secure in place with a lower
handle screw.
Note:
Ensure that the power cord
does not interfere with the catcher
flap and it can be opened and closed
easily.
2. Secure in place by screwing
the handle securing knobs
over the protruding ends of
the bolts.
Fitting the Upper Handle to the Middle Handle
1. Place the upper handle
over each side of the middle
handle. From the handle
securing set, fit the bolts
through the outer side of
the upper handle and then
through the hole in the middle
handle.
2. Secure in place by screwing
the handle securing knobs
over the protruding ends of
the bolts.
3. Pull the rubber clips over the
catcher frame.
