Adjusting the telescope length
1. Unlock the telescopic shaft lock.
2. With the lock released, the telescope arm can be pulled forward
out of the collar, thereby extending its reach. It can also be
shortened by pulling it back into the collar.
3. Close the telescopic shaft lock.
Attaching the shoulder strap
1. Wear the shoulder strap so that
it lies over the left shoulder.
4. HANDLE & CORD RETAINER
5. PREPARATION
1. Make a loop with the
extension cord (socket
end of cord), push it
through the hole and
secure over the hook.
3. Connect the extension cord to the
power lead. Route the power and
extension cord away from the work
area to prevent contact with the
chain.
2. Pull the extension cord
to secure it in position
over the cord retainer.
50
50
50
50
The cord retainer is used to “anchor” an extension cord (not included)
when it is connected to the power lead of the tool. It prevents the
extension cord from being accidentally disconnected from the tool
power lead or shaken loose during use.
50
50
50
50
Fitting the additional handle
1. Remove the 4 screws from the additional handle, then separate the
two halves.
Additional handle adjustment
3. Screw the handle loop to the
handle bracket from underneath
with the 4 screws provided.
Extension cord retainer
1. Loosen the 4 screws on the
underside of the handle. Slide the
handle to the desired position.
2. Retighten to secure in place.
2. Fasten the carabiner hook
to the shaft bracket on the
shaft.
2. Slide the handle loop over the rear
handle past the shoulder strap
attachment. Place the handle
bracket on the main shaft as
shown.