ASSEMBLY
7
BEFORE ATTACHING OR REMOVING ANY ACCESSORIES, BE SURE TO
DISCONNECT THE DEMOLITION BREAKER FROM THE POWER SUPPLY
Adjusting the Side Handle
The side handle (9) provides additional control, support and guidance for the
demolition breaker.
The side handle (9) is adjustable to any position around the
360° handle collar mount.
The side handle (9) will come assembled to the demolition
breaker, yet the handle locking knob (10) will need to be
tightened to secure the side handle (9) in place.
Loosen the side handle (9) by rotating the handle locking knob
(10) anti clockwise (Fig.1). Adjust the side handle (9) by rotating
around the 360° handle collar mount to the desired position and
retighten by turning the handle locking knob (10) clockwise.
Fitting and Removing SDS Max Accessories
Important!
Always lubricate the SDS max
accessory fitment prior to inserting them into the
demolition breaker. Using your finger, apply
grease sparingly to the shaft of the accessory from the tub of grease (14) supplied.
Lubricating the SDS max accessories will prolong the life of your demolition breaker.
Non-lubrication of accessories will void your warranty.
Note:
Prior to fitting a SDS max accessory, remove any dust or debris from the
SDS max shank of the accessory.
1. Pull the accessory locking sleeve (2) back towards the
body of the demolition breaker (Fig. 3). Rotate and
insert the SDS max accessory, making sure it has been
inserted as far as it will go, then release the accessory
locking sleeve (2).
2. With the accessory locking sleeve (2) released, check the
SDS max accessory has been locked into place by trying
to pull the SDS max accessory out.
Note:
The SDS max accessories will have a small amount (approx. 10-12mm) of
back and forth movement from the SDS max accessory holder (1), this is normal.
3. To remove the SDS max accessory, pull the accessory locking sleeve (2) back
towards the body of the demolition breaker, and remove the SDS max
accessory. Clean the SDS max accessory shank with a dry cloth after removal.
Note:
To avoid damage to the SDS max accessory holder (1), only use SDS max
accessories. Damage caused to the SDS max accessory holder (1) by using
incorrect accessories will not be covered under warranty.
Warning!
Accessories can be hot after use, always wear gloves to prevent
burns or lacerations.
Fig.1
Fig. 3
DBR-1500 Manual.qxd 5/11/10 3:17 PM Page 8