Ozito CDR-014, Instruction Manual

Page: 12 / 18

dRill dRiVeR opeRation (cont.)
11
changing the direction of Rotation
The direction of rotation can be changed with the
forward/reverse lever (4). This is located above the
variable speed trigger (6) (Fig. 5).
To select the forward drilling position, push the for-
ward/reverse lever (4) hard left. To select the reverse
drilling position push the forward/reverse lever (4)
hard right.
The variable speed trigger (6) can be locked off by pushing the forward/reverse
lever (4) into the middle of both forward and reverse positions.
torque Settings (tightening power of your drill)
When using your drill for various driving applications, it becomes necessary to
increase and decrease the power and torque in order to prevent the possibility of
damaging screw heads, threads, work pieces, etc.
In general, power and torque should correspond to the difficulty of the screw to be
driven. If torque is too high, the screws can be damaged or broken.
to adjust torque
Locate the arrow (a) on the front of the drill housing
(Fig. 6).
Identify the torque settings and 1 drill setting on
the torque adjustment collar (2).
Rotate the torque adjustment collar (2) to the
desired setting, aligning the required number on
the torque adjustment collar (2) with the arrow on
the drill housing.
To increase or decrease torque, rotate the torque adjustment collar (2). The
lower the number, the lower the torque setting. The higher the number, the
higher the torque setting.
Always check that the correct torque is selected by practising on scrap material prior
to carrying out a job.
Keyless chuck
A keyless chuck (1) is included on your drill to allow
for easy installation and removal of bits/accessories.
To open and close the keyless chuck (1), with one
hand hold the chuck collar (b) and rotate the chuck
body (c) with your other hand (Fig. 7).
The arrows on the chuck indicate in which direction
to rotate the chuck body in order to GRIP (tighten)
or RELEASE (unlock) the drill bit.
1.
2.
3.
1.
2.
3.
4.
1.
2.
3.
Fig. 6
Fig. 5
Fig. 7
WaRninG!
Remove battery from the drill before attempting to change
accessory. Failure to do so may cause serious personal injury.