Ozito CDR-013, Instruction Manual

Page: 9 / 18

cHaRGinG youR BatteRy
8
The drill’s battery (7) has been shipped in a low charge condition, and requires
charging prior to use.
Connect the charging jack (9) to the charging
cradle (10) (Fig. 1).
Plug the charging adaptor (8) into a mains
power outlet.
The green LED light on the charging cradle (10)
will illuminate showing that power is being
supplied to the charging cradle (10).
With the battery (5) sitting flat on a bench/table,
slide the charging cradle (10) into the recess of
the battery terminals ensuring a firm connection
(Fig. 2).
When the battery (7) is properly connected, the
red LED light on the charging cradle (10) will
illuminate signifying that the battery (7) is
on charge.
The battery takes 3 – 5 hours to charge. Charging
starts automatically. Remove the battery (7) from
the charging cradle (10) after 5 hours.
note: Red LED will always illuminate until battery is removed. Green LED will always
illuminate until the mains power is disconnected.
initial charge
The battery (7) will not reach its full charge the first time it is charged.
The red LED will remain illuminated until the charger is disconnected from the
mains power outlet.
The battery (7) requires 4 to 5 charging cycles to reach its optimum charge and
run time. Run time can increase significantly after 4 to 5 charge cycles.
caution:
Disconnect the charger adaptor from the mains power when charger is not
in use.
Subsequent charges
After normal usage, approximately 3–5 hours of charging time is required to
fully recharge the battery (7).
If the battery (7) is completely discharged, 5 hours or longer of charging time
will be required to fully recharge it.
1.
2.
3.
4.
5.
6.
1.
2.
3.
1.
2.
Fig. 1
Fig. 2