MAINTENANCE
12
•
Place switch in “O” off position and unplug from the power supply before the
blower vac is serviced, cleaned or maintenance is performed.
•
Keep air intake clean and air vents free of debris to avoid overheating the
motor.
•
Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent
on a damp cloth is recommended. Water must never come into contact with the
tool.
•
If the blower vac vibrates abnormally, stop motor immediately. Abnormal
vibration usually indicates a mechanical problem continued operation could
lead to injury or damage.
•
No lubrication is necessary as the motor is equipped with lifetime-lubricated
bearings.
•
Keep the ventilation vents of the tool clean at all times, if possible, prevent
foreign matter from entering the vents.
•
After each use, blow air through the tool housing to ensure it is free from all
dust particles which may have built-up.. Build up of dust particles may cause
the tool to overheat and fail.
•
If the enclosure of the tool requires cleaning do not use solvents but a moist
soft cloth only. Never let any liquid get inside the tool; never immerse any part
of the tool into a liquid.
Carbon brushes
When the carbon brushes wear out the tool will spark
and/or stop. Discontinue use as soon as this happens.
They should be replaced prior to recommencing use of the
tool. Carbon brushes are a wearing component of the tool
and therefore not covered under warranty. Continuing to
use the tool when carbon brushes need to be replaced may
cause permanent damage to the tool.
Carbon brushes will wear out after many uses, when the carbon brushes need to
be replaced take the tool to an electrician or a power tool repairer for a quick and
low cost replacement. Always replace both carbon brushes at the same time.
Note:
Ozito Industries will not be responsible for any damage or injuries caused by
repair of the tool by an unauthorised person or mishandling or mistreatment of the
tool. This tool is designed for DIY use - use in commercial or industrial
environments will void the warranty.
Carbon brushes
BVP-2400 Manual.qxd 9/11/09 5:40 PM Page 12