2. SANDING BELT
3. BELT ADJUSTMENT
OPERATION
CAUTION:
ENSURE BODY PARTS, CORDS, WORKPIECES
AND ANY LOOSE ITEMS ARE CLEAR OF THE SANDING
BELT BEFORE PERFORMING THE FOLLOWING STEPS.
CAUTION:
THE ARROWS ON THE BELT MUST BE
ALIGNED WITH THE MARKINGS ON THE BELT SANDER.
INCORRECT FITMENT COULD CAUSE THE BELT TO
BREAK. BELTS ARE NOT COVERED BY THE WARRANTY.
2 Release the belt tension by
pushing the tensioning lever
all the way towards the front.
2 Remove the belt from the rollers
1 Place the sander on its
left side.
1 Release the belt
tension by pushing the
tensioning lever all the
way towards the front.
4 Once the belt is in the
correct position, pull
the tensioning lever
backwards to secure
the belt.
3 Place the belt over the front and rear rollers.
Fitting the Sanding Belt
Removing the Sanding Belt
It is necessary to ensure the belt is tracking correctly, in a straight line,
to avoid the belt ‘tracking off’ the belt sander’s rollers.
2 Press the on/off trigger to
start the sander and observe
the tracking of the sanding
belt.
4 Adjust the belt until its outer edge is even with the outer edge of
the rear roller. Make sure that the belt does not rub against the rear
guide strip.
1 Turn the sander
upside down and hold
it firmly with one hand.
3 If the belt tracks
outwards, rotate the
tracking knob anti-
clockwise.
If the belt tracks
inward, rotate the knob
clockwise.
Tracking Adjustment
