MAINTENANCE
DESCRIPTION OF SYMBOLS
TROUBLESHOOTING
Power tools that are no longer usable should not be disposed of
with household waste but in an environmentally friendly way. Please
recycle where facilities exist. Check with your local council authority
for recycling advice.
Recycling packaging reduces the need for landfill and raw materials.
Reuse of recycled material decreases pollution in the environment.
Please recycle packaging where facilities exist. Check with your
local council authority for recycling advice.
• There are no user serviceable parts in the blower vac; if a fault is suspected
or the supply cord requires replacement, return the blower vac to a power tool
repairer.
• Keep air intake clean and air vents free from debris to avoid overheating the
motor.
• Do not use cleaning agents to clean the plastic parts of the blower vac. A
mild detergent on a damp cloth is recommended. Water must never come into
contact with the blower vac.
• If the blower vac vibrates abnormally, stop motor immediately. Abnormal
vibration usually indicates a mechanical problem continued operation could
lead to injury or damage.
• No lubrication is necessary as the motor is equipped with lifetime-lubrication
bearings.
• Keep the ventilation vents of the blower vac clean at all times, if possible,
prevent foreign matter from entering the vents.
• After each use, blow air through the blower vac housing to ensure it is free
from all dust particles which may have built-up. Build up of dust particles may
cause the blower vac to overheat and fail.
• If the enclosure of the blower vac requires cleaning do not use solvents but
a moist soft cloth only. Never let any liquid get inside the blower vac; never
immerse any part of the blower vac into liquid.
• When not in use, the blower vac should be stored in a dry, frost free location
not within the reach of children.
Note: Ozito Industries will not be responsible for any damage or injuries caused
by the repair of the blower vac by an unauthorised person or by mishandling
of the blower vac. This tool is designed for DIY use - use in commercial or
industrial environments will void the warranty.
Collection Bag
BLVBA-001
Spare parts can be ordered from the Special Orders Desk
at your local Bunnings Warehouse.
For further information, or any parts not listed here, visit
www.ozito.com.au or contact Ozito Customer Service:
Australia 1800 069 486
New Zealand 0508 069 486
E-mail: [email protected]
SPARE PARTS
Double insulated
V
Voltage
Regulator compliance mark
Hz
Hertz
n
o
No load speed
W
Wattage
/min
Revolutions or
reciprocation per minute
Warning
Keep by standers away
Keep hands out of the openings while the tool is running
~
Alternating current
Wear dusk mask
m
3
Metres cubed
Disconnect from power supply
when performing maintenance
Wear eye protection
Do not use in wet weather
Be aware of people around you and do not direct
towards them
Read operating instructions
before use
Disconnect and discontinue use
should the power-cord be damaged
WARNING!:
ENSURE THE BLOWER VAC IS
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
Problem
Cause
Remedy
Poor Suction
Collection bag full
Empty the collection bag
Clogged air tubes
Remove any debris or built
up within the upper and
lower tubes.
Clogged collection
bag connector
Remove the collection bag,
remove build up of debris
from connector & outlet in
the housing.
CARING FOR THE ENVIRONMENT
Clearing Debris
There is an access point on the right side of the blower to allow
debris to be cleared easily from the impeller.
1 Unscrew the locking knob
to allow the access point to
pivot open.
2 Remove any debris from
the impeller.
3 Ensure the locking knob is
tight after cleaning.
