![background image](http://html.mh-extra.com/html/ozito/bjk-1010/bjk-1010_instruction-manual_1666171010.webp)
10
adjusting the cutting angle
When using your biscuit joiner to make mitred joins, it is necessary to change the angle of
cut to match the bevel for an accurate join.
The procedure for adjusting the cutting angle is outlined below:
Loosen the bevel locking knob (2) (rotate anti-clockwise)
1.
and move the fence (7) to the desired angle on the bevel
adjustment scale (4). (Fig. 10)
Ensure that the face of the fence (7) is flush with the
2.
workpiece. Retighten the bevel locking knob (2) (rotate
clockwise). (Fig. 11)
Your choice of biscuit is dictated by the size of the workpiece. The following table shows
the relationship of the markings on the depth adjustment knob (9) to cutting depth and the
biscuit used according to material thickness.
marking
Biscuit
cutting depth
0
#0
8mm
10
#10
10mm
20
#20
12.5mm
M
N/A
13.5mm (maximum)
note:
It is recommended to check the accuracy of the depth adjustment knob (9) as part of
your setup procedure. This can be achieved by setting the depth adjustment knob (9) using
the procedure outlined above, then extending the blade until the depth stop contacts the
depth adjustment knob (9).
Measure the distance between the blade and the face of the fence
(7). (Fig. 9) To adjust the scale, rotate the depth stop screw until
the depth of the blade matches the scale as outlined in the above
table. Rotate depth stop screw anti-clockwise to increase the depth,
and clockwise to decrease the depth.
preparation & Set-up
Fig. 11
Fig. 10
Fig. 9