MAINTENANCE
5. POLISHING
6. MAINTENANCE
OPERATION
Changing the Wheels
1. Remove the 3 screws that
hold the side section of the
safety hood and remove the
wheel guard cover.
2. With a spanner, hold the
wheel nut on the opposite
side in position, while
loosening the wheel nut of
the wheel you wish to change
with another spanner.
NOTE:
The grinding wheel on the left is fastened with a left handed
thread and the wheel on the right with a right-handed thread.
3. Remove the flange and
replace the grinding wheel.
4. To assemble, proceed in
the reverse order.
5. Manually spin the newly
mounted wheel to check
that it rotates freely prior
to operation.
Carbon brushes
Carbon brushes will wear out after
many uses, causing the Bench
Grinder to spark and/or stop.
The brushes are a wearing
component of the Bench Grinder and
should be replaced prior to the carbon
wearing out completely.
Take the Bench Grinder to a suitably
qualified electrician or power tool repairer for replacement.
Always replace both brushes at the same time.
NOTE:
Ozito Industries will not be responsible for any damage or
injuries caused by the repair of the Bench Grinder by an unauthorised
person or by mishandling of the Bench Grinder.
1. Apply a thin coating of polishing
paste (supplied) to the surface of
the Polishing wheel.
2. Press the workpiece onto the wheel
and move it back and forth across
the surface of the wheel.
3. Always carry out polishing work in the
direction of rotation of the polishing
wheel.
IMPORTANT!
POLISHING IN THE OPPOSITE DIRECTION TO
THE DIRECTION OF ROTATION OF THE GRINDING WHEELS
CAN CAUSE DAMAGE TO THE WHEEL, WHICH IN TURN
CAN RESULT IN INJURIES.
IMPORTANT!
BEFORE CLEANING YOUR BENCH GRINDER
OR CARRYING OUT ANY MAINTENANCE PROCEDURE,
MAKE SURE THAT THE MOTOR IS OFF AND THE TOOL
DISCONNECTED FROM THE POWER SUPPLY TO
PREVENT ACCIDENTAL STARTING.
