Connecting The Air Tools
1. Pull back the sleeve on the
air hose Nitto fitting and
insert the male Nitto on the
desired air tool.
2. Release the sleeve; the Nitto
coupling should click into
place.
3. Check that the fitting is secure by tugging gently on the
connector. If the hose detaches, repeat steps 2 & 3, pushing the
Nitto connector firmly into the outlet.
4. To disconnect the air tool, retract the sleeve on the female Nitto
fitting and disconnect the air hose from the air tool.
WARNING!
ENSURE YOU HAVE A FIRM GRIP ON THE
AIR HOSE WHEN DISCONNECTING IT FROM THE AIR
COMPRESSOR, AS PRESSURISED AIR IN THE TANK
MAY CAUSE IT TO WHIP AROUND AND INFLICT INJURY
OR DAMAGE.
Attaching The Inflation Nozzles
The inflation nozzles can be attached
to the air inflation gun.
The needle nose nozzle can be used
for sports balls.
The tapered nozzle can be used for rubber
dinghies, small inflatable swimming pools & air
bed.
Note:
A suitable air compressor will be required to
inflate these.
1. Press down the clamp and
insert the desired nozzle.
2. Release the clamp and
ensure the nozzle is securely
attached by tugging gently
on it.
1. Water Nozzle
2. Water Inlet Port
3. Nitto Style Fitting
4. On/Off Trigger
5. Adjustable Nozzle
6. 1L Tank
7. Pressure Gauge
8. Hose Clamp
9. 100mm Inflator Nozzle
10. Material Cup
11. Spray Nozzle
12. Fan Adjustor
13. Spray Regulator Dial
14. Material Cup Lid
AIR TOOLS
KNOW YOUR PRODUCT
1. ASSEMBLY
SETUP & PREPARATION
2
6
7
8
9
10
11
1
5
13
12
14
4
3
WARNING!
ENSURE THE TOOL IS TURNED OFF AND
DISCONNECTED FROM THE POWER SUPPLY BEFORE
PERFORMING ANY OF THE FOLLOWING OPERATIONS.
ONLINE MANUAL
Scan this QR Code with your mobile
device to take you to the online manual.
a.
b.
AIR/WATER WASHING GUN
1L SPRAY NOZZLE
WASHING GUN
AIR INFLATION GUN
LONG NOSE AIR
BLOW GUN
0.6L GRAVITY FED
SPRAY GUN