2. SAFETY GUARDS
3. CHANGING DISCS
1 Depress and hold spindle
lock button. Rotate the
spindle to locate the lock
position.
1 Place the inner flange
onto the spindle, ensuring
the notches align with the
grooves.
3 Screw the outer flange onto the spindle. The direction of the
outer flange differs for the cutting and grinding disc as shown
below.
Two sets of flanges are provided with your angle grinder to enable
the fitment of a cutting or grinding disc. Ensure you use the
correct flanges for the application. Paper washers are for use with
cutting discs to prevent the outer flange from self tightening during
operation.
2 Use pin spanner to loosen
the outer flange. Remove
the inner and outer flange.
2 For grinding, insert the
provided disc with the
label facing up, (facing the
grinder).
OPERATION
Removing
Fitting a Disc
Safety Guard
A safety guard should be used at all times whilst operating the angle
grinder.
1 Release the guard lever
and loosen guard nut.
Attaching
Removing
3 Tighten guard nut then
close the guard lever.
1 Release the guard lever
and loosen guard nut.
2 Align tabs on the guard with
slots on the guard collar
and then remove guard.
Note:
Outerflangesarethreaded,Innerflangesarenot.
2 Place guard on spindle
neck by aligning the
notches. Then rotate into
the desired position.
NOTE:
IF THE GUARD NUT IS OVER-TIGHTENED, THE
GUARD LEVER WILL NOT BE ABLE TO CLOSE PROPERLY.
IF THE GUARD NUT IS TOO LOOSE, THE GUARD LEVER
WILL CLOSE BUT WILL NOT SECURELY FASTEN THE
GUARD TO THE SPINDLE NECK.
Use ONLY the semi-
open Grinding Guard
with a grinding disc.
Use ONLY the fully
enclosed Cutting
Guard with a
cutting disc.
4 Depress and hold spindle
lock button. Firmly tighten
the outer flange with the pin
spanner.
Cutting Disc:
The raised ring on the flange
must face away from the
cutting disc.
Grinding Disc:
The raised ring on the flange
must locate within the hole on
the grinding disc.
NOTE:
FOR CUTTING, ENSURE A PAPER WASHER IS
PLACED BETWEEN THE INNER FLANGE AND CUTTING DISC
TO PREVENT SELF TIGHTENING DURING OPERATION.
CAUTION:
INSPECT THE DISC BEFORE FITMENT TO ENSURE
IT IS NOT CRACKED OR DEFORMED. THE GRINDING DISC
IS SUITABLE FOR GRINDING TASKS ONLY. ONLY USE DISCS
WITH A DIAMETER OF 230MM.
