2. PREPARATION
1. Lift up the grass catcher flap
with one hand and guide the
catcher with your other hand
over the two hooks on the
mower housing.
3. To remove, raise the grass catcher flap and lift the grass catcher out.
2. Lower the grass catcher and
allow it to sit in place. Lower
the grass catcher flap.
Adjusting the Cutting Height
Fitting and Removing the Grass Catcher
WARNING!
ONLY FIT AND REMOVE THE CATCHER
WHEN THE MOWER IS SWITCHED OFF AND THE
MOTOR HAS COME TO A STOP.
Note:
The grass catcher flap is
held against the grass catcher by
a spring.
The cutting height can be set between 25mm - 75mm in 6 intervals and can
be read off the scale.
1. Pull lever outwards away from
the mower body.
2. Adjust until the required cutting
height is selected.
3. Release lever and check that it is
securely seated in the required
cutting height position.
WARNING!
WHEN FITTING THE GRASS CATCHER
AFTER EMPTYING, ALWAYS ENSURE THERE IS NO
BUILD UP OF GRASS IN THE GRASS CHUTE.
Grass Catcher Indicator
The grass catcher is fitted with an
indicator at the rear of the catcher to
help identify when to empty.
If the indicator drops down while
operating then the grass catcher is full
and needs emptying.
Adjusting the Telescopic Handle
Note:
Ensure that both sides
are set to the same position.
WARNING!
ENSURE THE TOOL IS SWITCHED OFF
AND BATTERIES ARE DISCONNECTED BEFORE
PERFORMING ANY OF THE FOLLOWING TASKS.
1. To adjust the height of the handle
flip up the two quick-release
levers.
2. Adjust the handle into the
desired height. To lock in place
flip the two quick-release levers
back into the closed position.
3. To adjust the angle of the
handle flip up the two
handle angle quick-release
levers. Three settings
available for the angle.
Ensure one of the
three positions
available is selected
otherwise the
mower will not
operate.
4. To lock in place flip the two handle angle quick-release levers back into
the closed position.
