4 • Oz Charge manual
www.ozcharge.com.au
LED / LCD STATUS INDICATOR TABLE:
RUN Button:
The RUN button can be pressed once to activate RUN
mode once the device is fully charged and Ready To Use.
If RUN mode is activated, you can press the RUN button
again to stop RUN mode.
Pressing and holding the RUN button when the device is
Ready To Use will extend the start delay time up to 120
Seconds. The default start delay is 10 seconds.
If the device is not connected to any battery or input, press
and hold the RUN button for 1 second to turn the LCD on.
Note:
The LCD will only turn on and display the devices
voltage if the voltage is over 10 Volts.
Battery Bypass Mode:
If the battery has been removed/
bypassed or the battery voltage is below 1V, you’ll need
to press and hold the RUN button for 3 seconds.
All Safety
protection is disabled so please ensure you have made the
right connections.
LED
Status
Description
Charging LED
Blue
ON
The Charging LED will illuminate blue while the device is being charged
Full / Ready LED
Green
Flash
The Full/Ready LED will flash green to indicates the device is charged and ready
to use. READY TO USE will also be scrolling across the LCD.
Green
ON
Indicates the unit is in RUN mode (outputting power). During RUN mode all
safety protection is DISABLED. Do not short circuit or make a reverse polarity
connection while in RUN mode. RUN mode will time out after 30 seconds or you
can press the RUN button to stop RUN mode.
Note: If both the Charging and Full/Ready LED are OFF, this indicates no charge input has been detected.
LCD
Status
Description
LCD
ERR
If the LCD displays ERR, this means the leads were connected reverse polarity.
LCD
ERR
ERR NO BATT. PRESS RUN TO BYPASS.
This means no battery has been
detected, the output leads or battery is shorted, or the battery voltage is below
1V. If you wish to proceed, you need to press and hold the RUN button for 3
seconds until the countdown timer starts.
All Safety protection is disabled.
LCD
RUN
If the LCD displays RUN and the devices voltage, the device is outputting power
LCD
CAR
If the LCD displays CAR then a voltage, this is the voltage of the vehicles battery
LCD
USB
If the LCD displays USB then a voltage, this is the voltage of the USB input source.
LCD
DC I
If the LCD displays DC I then a voltage, this is the voltage of the DC input source
LCD
READY
TO USE
If the LCD displays READY TO USE, the device is charged and ready to go.
Note:
If the devices voltage is under 10V, the unit / LCD will not turn on until you charge the device.
Charging Full /
Ready
RUN
RESCUE MATE
12 Volt 750 Amp Max.
Super Safe Jump Starter
Model: OC-RM750
Model: OC-RM750
RED
BLACK
CONNECTION
IN
VEHICLE
(
NEGATIVELY
EARTHED
)
Model: OC-RM750
RED
BLACK
CONNECTION
IN
VEHICLE
(
POSITIVELY
EARTHED
)
Model: OC-RM750
