12
7.
INSTALLATION OF THE UNIT
7.1.
Selecting the mounting location
It is recommended to install the Unit in a heated room such as bath, storage room, boiler room or an
attic. Make sure, that there is sufficient space to install not only the Unit itself, but also auxiliary
ventilation system components – noise silencers or air distribution boxes.
Operating conditions:
+15
o
C - +24
o
C, relative air humidity <= 55%.
IT IS PROHIBITED
to operate OXYGEN X-Air C200E ventilation device during cold period of a year in
premises with relative humidity level exceeding 55%. Excessive moisture condensation inside the Unit
can cause leakage or damage Units electronic components. Usage of the Unit in excess moisture
conditions will void the warranty!
The Unit should be installed horizontally with service cover looking downwards or upwards. L-shape
fastening brackets (provided) should be used to fasten Unit to the ceiling or flooring. Use ceiling pins
or locking sleeves (not included), depending on installation surface. It is recommended to use
vibroinsulation gaskets (not included) to ensure that Unit vibration will not be transferred to the
mounting surface.
7.2.
Connecting ducts
It is recommended to install outside air supply and exhaust ducts as far as possible from each other
to prevent the ingress of contaminated air back to premises. Please refer to local construction
regulations.
Make sure that outdoor humidity or precipitation will not get into the Unit, when connecting outside
air supply and exhaust ducts. Make sure that openings in the outside wall are installed lower than
corresponding ducts of the Unit. The air intake opening in the outside wall should be protected
against precipitation ingress to ventilation duct by grille or roof.
Summary of Contents for X-Air C200E
Page 2: ...1 ...
