Rev.0 LEPTON
Service
manual
OXYGEN S.p.A.
15
•
Remove the cooling fan (18 - Figure 5/a);
•
Cut the heat-restringent covers from the Z10-1 terminals (1 - Figure 5/a);
•
Disconnect the 3 motor power cables (Black / Red / Green) from the drive
power cables (Black / Brown / Blue), unscrew the 3 connectors so that you can
pull out and disconnect the power wires;
•
Pull out the signal connection cable on the top of the motor flange(4 - Figure
5/a);
•
Disconnect the ground cable (Yellow / Green) from where it is attached to the
motor casing (2 - Figure 5/a);
•
Remove the front shield unscrewing the 4 screws (9 – Figure 5/a). Disconnect
the 3 connectors from the electrical system (10 / 11 – Figure 5/a) and cut the
self-blocking band. These cables are connected directly with the DRIVE. Pull
them with care following their runway site under the frame, in order to preserve
the cable;
•
Disconnect the wires and cables attached directly to the drive:
o
RED drive wire (10 mm
2
section) from terminal 87 of the switch (12 –
Figure 5/a);
o
BLUE drive wire from the yellow wire of the scooter’s electrical system
(16 – Figure 5/a);
o
BLACK drive wire from the black wire battery (8/a – Figure 5/a)
•
Disconnect the cables from the DRIVE plug to the electric recharge system
(21 – Figure 5/a);
•
Remove all the 2 screws of the DRIVE, and remove the DRIVE (0 – Figure
5/a).
