Ref 7 mm
(Linkage Ball Position)
90°
Ref 7mm
(Linkage Ball Position)
90°
5 mm
4mm
Chapter 14: Servo & Servo Rod Prepareration
- You should now do some initial setup of your FBL unit and servos.
- We recommend you select a new model in your transmitter, and reset your FBL unit and start with a clean setup in it as well.
- After binding your transmitter to the receiver system used with the FBL unit, work your way through the FBL setup instructions to the point
you plug in your servos.
- Now set your collective stick in the middle position, and position the servo arms as close to the correct positions you can on each servo
see the following pages for arm orientations on the various servos.
- Next confirm the servos work in the correct direction, then return the collective stick to the center position.
- Now use your FBL unit to trim the servos so the arms are exactly horizontal (see pictures below).
- This procedure varies between units. Carefully label the position of the servos, then proceed with the installation of the servos as shown.
Cyclic Servo.
Linkage Ball Direction: cyclic servo
Linkage Ball, must installed as shown.
Arm position with zero deg pitch
and centered cyclic stick.
OXY0521-Linkage
ball 3x1.5mm
(Box 1-1/Bag 7)
Reuse STD
Servo Arm
Reuse STD
Servo Screw
Positive
Pitch
Negative
Pitch
Cut here
Cut here
Linkage Ball Direction: The Tail servo
Linkage Ball must be installed as shown.
Arm position with zero deg pitch
and centered rudder stick.
Reuse STD
Servo Screw
Reuse STD
Servo Arm
Nose Right
Nose Left
page 28
Servo Rod Assembled
(Box 1-1/Bag 7)
It is really important the servo rods screw onto
the linkages the same amount. The Plastic
ball links have a Lynx logo to give you
information about turn adjustment, but have
a symmetrical ball socket shape and can be
installed in either direction to achieve the
best fine tuning.
OXY0526-Plastic
Linkage Ball 3mm
OXY0520-M1.4X11
Threaded Rod
Servo Rod Refference
for Servo type A
Servo Rod Refference
for Servo type B
OXY0521-Linkage
ball 3x1.5mm
(Box 1-1/Bag 7)
CA Glue
CA Glue
