OXO FUNSTRIP 2R, User Instruction, Page: 5 / 10

User Manual - Funstrip 2R V1 03/2017 5/10
3. Menu button
This button will call up the unit operation mode between DMX and
Chase mode.
4. Up button
This button will increase the displayed value in the LED display.
5. Down button This button will decrease the displayed value in the LED display.
6. Enter button This button will active the different functions in DMX and Chase mode.
Note: In the Chase mode, Menu key is used to only activate Chase
Dimmer (d), Chase Program (P), Chase Speed (SP).
In the DMX mode, only used to only select DMX Address (A), Channel
(CH).
7. DMX Out This connector accepts your DMX signal through to the next unit.
8. DMX In This connector accepts your DMX input signal.
9. Power Input
AC 230V-50/60Hz, Max 16A. The supply power is input into your unit
via this connector. Be sure to always proper voltage.
10. Power Input
AC 230V-50/60Hz, Max 16A. This connector send the supply power to
the next unit.
11. Fuse
F6.3A250V 5*20mm. These fuses prevent you from overloading
damaging your unit. Be sure to always replace with the exact same
type fuse.
12. Power Switch
Turn on/off the power supply.
5. Operation Guide
Operation Modes:
The «Funstrip DMX» has two different operation modes. It can be used a 10 channel
chaser or as a 01, 02, 05, 10, 15 channel DMX dimmer. Please follow illustrations below
to operate the unit in your desired mode.
DMX Mode:
Use this operation mode only when you are about to use the unit as a DMX dimmer.
This function can allow you set your unit dimmer function as a 01, 02, 05, 10, 15 channel
DMX dimmer and DMX address.