9
4.1 To get started, you will need:
• A Zigbee Gateway.
• A mobile phone with a mobile APP installed.
4.2 Adding to the gateway's network
1. Set your gateway to permit joining (see your gateway's manual).
2. Power on the Dimmer Switch and make sure the LED indicator is
flashing slowly (If not, reset it to factory defaults).
3. After few seconds the Dimmer Switch will join the gateway
automatically and the LED indicator will become steady. Press any
button to check if the LED status flashes rapidly for 1 times, which
means it successfully joined.
Note:
If the Dimmer Switch fails to join the gateway's network within
90 seconds, simply reset the Dimmer Switch and retry.
Configure Network
4
4.3 Pair the Dimmer Switch with other device
Note:
Please make sure other device are also added into the same
network of the gateway and can be controlled by the mobile app
before you proceed.
1. Power your devices.
2. Enable your device into identify mode. Your device will flash during
the identify process.
3. Place your device near to the Dimmer Switch, then press and hold
the "+" or "-" button on the Dimmer Switch for 8 seconds until the LED
indicator flashes rapidly for 3 times.
4. Your bound device will stop flashing when pairing successfully.
Tip: If pairing failed, you need to repeat the pairing and try again.
