5.Front Panel Operation
13
Figure 5-3: Set the frequency using number keys
To Set the Amplitude
Press
F2
, confirm whether the "
Ampl
" menu item is highlighted; if not, press
F2
to
switch into "
Ampl
". In
Parameter 2
, a cursor appears under the value of amplitude. Use
the
knob
or the number keys to set the desired value.
To Set the Offset
Press
F3
, confirm whether the "
Offset
" menu item is highlighted; if not, press
F3
to switch into "
Offset
". In
Parameter 3
, a cursor appears under the value of offset. Use
the
knob
or the number keys to set the desired value.
To Set the High Level
Press
F2
, confirm whether the "
Hi_Level
" menu item is highlighted; if not, press
F2
to switch into "
Hi_Level
". In
Parameter 2
, a cursor appears under the value of
amplitude. Use the
knob
or the number keys to set the desired value.
To Set the Low Level
Press
F3
, confirm whether the "
Lo_Level
" menu item is highlighted; if not, press
F3
to switch into "
Lo_Level
". In
Parameter 3
, a cursor appears under the value of
offset. Use the
knob
or the number keys to set the desired value.
To Output Square Signals
Press
button to call the user interface of Square signal, the Square waveform
parameters can be set by operating the Square setting menu on the right.
The parameters of Square waveform are: Frequency/Period, Amplitude/High Level,
Offset/Low Level, Duty. You can operate the menu by using the menu selection buttons
on the right.
To set the Frequency/Period, Amplitude/High Level, Offset/Low Level, please refer to
To
Output Sine Signals
on page 12.
The frequency range is 1
μ
Hz - 5 MHz; the period range is 200 ns - 1 Ms.
