OWIM Powerfix Profi+ HG01701C, Operation And Safety Notes

Page: 13 / 86

13 GB
Note: When measuring under the measure-
ment range, the display shows ‚ 0.0% ‘ or
‚ Lo ‘. For measurements above the measure-
ment range, the display shows ‚ Hi ‘.
Remove the protective cap
1
.
Press both measuring pins
2
against the
surface at the same time. After 1-2 seconds
you can read the percentage value.
If you are taking a measurement in an area in
which you cannot read the display, press the
button to freeze the result on the display. The
display will then also show the lock symbol.
Press the button again to take another
measurement.
If you have completed your measurement,
switch the moisture measuring device off with
the button. Then reattach the protective cap.
Note: The moisture measuring device
switches itself off automatically if the device is
not used for 60 seconds.
Battery display
If the battery charge status is low, the battery
symbol
appears on the display
7
. Replace
the battery as quickly as possible if this symbol
appears. Empty batteries can falsify the measured
result. The battery change is described in the
section „Inserting/changing the battery“.
Temperature display
You can change the temperature display between
°C and °F by holding down the button
4
for
approximately 5 seconds.