Here you see the OWC Mercury On-The-Go Pro drive inserted into the acrylic enclosure,
ready to have it’s end cap attached.
Insert the acrylic endcap, fully sliding it over the bridge card ports.
Once you have the endcap on, attach it to the enclosure using the 2 included small
Phillips screws. The location is circled above. You will have 4 larger screws remaining, they
are extra.
Do not exert too much force while screwing these in, you can accidentally strip the screw
head easily.
OWC Mercury On-The-Go Pro
Chapter 2 - System Setup
➇
➈