Protective Screen
Figure 2.
Pour the additional bags of
media onto the burner
support. Spread the
media evenly covering the
burner.
Protective Screen
Figure 1.
Pour the first bag of the
lava granules media into
the burner support.
Figure 2.
Pour the additional bag of
lava granules onto the
burner support. Spread
the media evenly covering
the burner.
Page 8
CAUTION:
BURN HAZARD. GEM, MIRRORED and CRUSHED GLASS and LAVA GRANULES
WILL REMAIN HOT FOR SOME TIME AFTER USE.
YOU MUST MAINTAIN THE LAYOUT AS SHOWN TO ENSURE PROPER OPERATION OF YOUR FIRE PIT.
IF YOU NEED TO REPOSITION ANY MATERIAL TO MAINTAIN THE PROPER LAYOUT, USE HEAT
RESISTANT GLOVES OR ALLOW MATERIAL ADEQUATE TIME TO COOL BEFORE HANDLING.
CAUTION:
Lava granules used in a fire pit are porous and when heated up to normal operating temperature
can cause trapped gasses or moisture to expand and cause a "pop" and "launch" outside of the fire pit, which
could cause injury or property damage. Allow lava granules to completely dry after getting wet
,
rained on or
hosed off, before lighting and using the fire pit.
LAVA GRANULE PLACEMENT
Pour the lava granules into the Outdoor Fire Pit so that the burner
is covered by 1/2" and spread evenly.
NOTE: See Page 7 For Protective Screen Media Clearance
(See Figure 1 and 2)
Figure 1.
Pour the first bag of the
glass media into the
burner support.
MEDIA PLACEMENT
GEM, MIRRORED AND CRUSHED GLASS MEDIA PLACEMENT
Carefully inspect the carton for shipping damage. If any parts are missing or damaged, call your dealer.
Do not attempt
to install the appliance unless all parts are in good condition.
Correct installation is crucial to safe performance of your Outdoor Fire Pit.
Pour the mirrored, gem or crushed glass media into the
Outdoor Fire Pit burner so that the burner is covered.
NOTE: See Page 7 For Protective Screen Media Clearance
(See Figure 1 and 2)
CAUTION:
Due to high temperatures, the Fire Pit must be located out of traffic areas and away from combustibles
A.
B.
C.
