10. HOW TO REPLACE THE BRUSH ROLL (cont.)
Page 9
Always follow these procedures to verify or replace the brush roll in order to avoid
damaging the carpet beater.
STEP 5
STEP 6
Replace the brush roll
cover
Replace the carpet beater
(powerhead) cover
STEP 4
STEP 5
1- Lift the end of the brush roll to
release the belt.
2- Remove the old brush roll and
replace it with the new one.
3- Loop the belt around to the motor
pulley.
4- Make sure the belt is sitting in the
“belt groove” on the brush roll.
Remove/replace the
brush roll
1-Hold the opposite end of the brush
roll in place.
2-Push the belt end forward and
down while rotating the endplate
until it slides into place.
3-Turn the brush roll to make
sure it rotates freely.
Replace the
brush roll
STEP 7
Screw the powerhead
cover in place
1-Put the brush roll cover back over
the brush roll.
2-Replace the 2 screws and make
sure the cover is well attached.
1-The wand port must be in the
upright position and locked in place.
2-Put the cover back on top of the
electric carpet beater (powerhead).
3-Turn the carpet beater (power-
head) over.
4-Replace the screws, as illustrated in
step 1.
Replace the 7 screws as illustrated
above.
