7
PRGM
SET
NOTE
:
Before programming the opener, check to make sure there
are no objects in the garage door opening.
INTRODUCTION
Now that the Overhead Door® garage door opener is installed,
follow the steps in this manual to program the opener so that
the door opens and closes properly and all remote devices
operate correctly. The following steps are a guide to setting
opener so it functions properly.
The following steps list the order of programming the
opener’s functional settings for use.
1.
“TRAVEL LIMITS”
2.
“FORCE CONTROL”
3.
“REMOTE PROGRAMMING”
OVERVIEW OF POWERHEAD CONTROLS
This section describes the programming functions of the
opener. Use the following information to understand the
buttons and LED indicators used to program functions.
Powerhead
: There are 3 programming buttons and 2 LED
lights on the powerhead. Each of the buttons are used to
enter and complete the setup programming. The LED lights
indicate status or a function change by illuminating ON, OFF,
or ON FLASHING.
Term Definitions:
Travel Limits
Programmable setting to adjust how far door
travels up or down.
Force Control
refers to how much power is needed to
move (open/close) a particular door and does NOT require
programming.
Remote Programming
synchronizes remote devices
(remote and keypad) with the powerhead.
Speed Control
refers to how fast or slow the opener opens
and closes the door. This is factory set and does NOT require
programming. NOT available on all models.
Moves door up or down during
programming and advances
through menus.
Enters into and selects
programming menus.
• Just remember—
the pointed end of the button (like an
arrowhead) points in the direction the carriage will move when
that button is pushed.
NOTE
: Each programming step has a 30 second time limit for completion
after the function is initiated. After 30 seconds, two LED’s will illuminate RED
indicating time has expired and the step must be restarted. Restart the step as
many times as necessary to complete the programming.
DOOR
ORIENTATION
Standing under the opener’s powerhead – facing the door – looking
up – this is the view you will see of the programming buttons and
LEDs.
OPENER PROGRAMMING
3
LED Indicators
Program/Menu
Open Travel
Button
Close Travel
Button
Indicates various programming
modes and trouble codes.
PRGM
SET
PRGM
SET
PRGM
SET
There are 4 programs:
1.
Door Travel Limits.
-
This program is used to set how far the door
travels up and down.
2.
Remote Programs (default menu)–only required for
adding remote control transmitters.
-
Describes how to program remotes to sync with
additional remote control devices, wall consoles,
keypads and the powerhead.
3.
Force Setting Program.
-
This program controls the force applied during
the closing and opening of the door. They are
factory set and will rarely require adjustment only
under certain circumstances.
4.
Door Speed Program.
-
This program does not require manually initiated
changes.
NOTE
:
The 3 programming buttons are for programming
ONLY. These buttons CANNOT be used to operate the
opener once the required programming section has been
successfully completed.
Motion
Detector
(Select Models)
