11
PRGM
SET
PRGM
SET
NOTE
: The following instructions are for remote control transmitters
purchased separately in addition to those provided with this opener,
but can also be used if any remote(s) may require re-programming.
NOTE
: Each programming step has a 30 second time limit for
completion after the function is initiated. After 30 seconds, two
LED’s will illuminate RED indicating time has expired and the step
must be re-started. Restart the step as many times as necessary to
complete the programming.
NOTE
: Do not hold remote too close to the powerhead when
programming remote buttons.
NOTE
: Each button on each remote must be programmed
separately, following these steps.
1. Remove the battery’s protective film from the
remote by pulling straight out.
2. Press and hold the SET/PRGM button on the
opener for two seconds.
•
The ROUND LED will turn BLUE.
•
The LONG LED will then flash PURPLE.
3. Stand at least 5 feet away from opener and
slowly press and release the desired button on
the remote two times.
•
Both opener LEDs will flash and turn off
indicating the remote has been programmed.
4. Press the desired remote button again.
•
The opener should run.
To program the same remote for other garage door
openers, repeat the steps above using one of the other
remaining remote buttons.
REPEAT STEPS 1 TO 4 FOR EACH OPENER AND
REMOTE
NOTE:
It is possible to press the remote button too quickly
or lightly. If the LEDs do not go off, press the remote button
several more times to achieve confirmation.
BASIC PROGRAMMING IS COMPLETE AND YOUR GARAGE
DOOR OPENER IS READY TO USE.
See page 19 to erase remote devices from memory.
Flashing
2. Enter Programming Mode
4. Test Remote
1. Activate Remote(s)
Solid Blue
PRESS 2
SECONDS
& RELEASE
Flashing Purple
3. Press Remote Button Twice
PROGRAMMING ADDITIONAL REMOTE CONTROLS
THE REMOTE CONTROLS INCLUDED WITH
THIS OPENER HAVE BEEN
PROGRAMMED AT THE FACTORY FOR YOUR
CONVENIENCE.
PRGM
SET
