12
1-2.
Completely remove the guide (Q) and the support bar (F).
3.
Drill a pilot hole for the sliding door guide (Q) using a ø1/8” (3mm) drill bit.
4.
Place the 2 support bar’s anchors (D & D1) back on their wall mark, then mark their holes on the wall.
5-6.
Drill a hole on the center marks with a ø5/16” (8mm) drill bit and insert the wall anchors (HH) using a
rubber mallet. Fix the center fitting on the support bar’s anchor (D & D1) using the screws (GG).
Note: Before continuing, place the door panel (J) inside the shower enclosure to facilitate future steps!
SUPPORT BAR INSTALLATION
3
ø1/8”
3mm
4
ø5/16”
8mm
5
2
F
C
D
D1
&
C
Q
1
HH
6
GG
D
D1
&
