Checking the tubing or the flexible hose per monthand each time the cylinder is changed.
The tubing or the flexible hose must be changed within the prescribed intervals or within one
year.
The hose assembly must be replaced prior to the appliance being put into operation if there is
evidence of excessive abrasion or wear, or if the hose is damaged, and that the replacement
hose assembly shall be that specified by the manufacturer.
The heater should be inspected before use and at least annually by a qualified service
person. More frequent cleaning may be required as necessary. It is imperative that control
compartment, burners and circulating air passageways of the appliancebe kept clean.
Shut off and check heater immediately if any of the following conditions exist:
The smell of gas in conjunction withextreme yellow tipping of the burner flames.
Heater does not reach a proper temperature. A temperature less than 5 will cause restricted
heat flow and the appliance will not work properly.
The appliance starts making popping noises during use (a slight popping noise is normal
when the appliance is extinguished).
The regulator & hose assembly must be located out of pathways where people may trip over it
or in area where the hose will not be subject to accidental damage.
Any guard or other protective device removed for servicing the heater must be replaced
before operating the heater.
Children and adults should be warned of the hazards of high surface temperatures and
should stay away to avoid burns or clothing ignition.
Young children and pets should be carefully supervised when they are in the area of the
heater.
Clothing or other flammable materials should not be hung from the appliance, or placed on or
near the appliance.
Do not place articles on or against this appliance. Certain material or items when stored
under or near this appliance will be subjected to radiant heat and could be seriously damaged.
Do not use or store flammable materials near this appliance.
Do not spray aerosols in the vicinity of this appliance while it is in operation.
Always maintain at least 0.9m clearance from combustible materials.
Always position the appliance on a firm level surface. An amply ventilated area must have a
minimum of 25% of the surface area open. The surface area is the sum of the walls surface.
