7
PACKING AWAY YOUR AWNING
Zip up all the windows and doors before deflating.
Unpeg the guy lines, storm straps and most of the pegs around the
awning - leaving the four corners pegged out.
Open each of the Dynamic Speed Valves in turn and press in the quick
release button. Leave the button pressed in.
Unpeg the four corners and pull the awning out of the awning channel.
Lay the awning flat on the ground and push as much air out of it as
possible.
Fold the awning lengthways
from the opposite ends to the
valves to push all the air out.
Make a long thin sausage shape.
Begin to roll the awning as tight
as possible towards the valves
to expel all the air as you roll.
Place the rolled awning on to
the bag and pull the sides up
round it. Finally, Zip up the bag.
Measure the width of the bag
up against the width of the fold-
ed awning to make sure the
awning is going to fit.
6
WARNING: Never unzip the zips on the protective
sleeves whilst the AirFrame Tubes are inflated. This will
result in the tube bursting or ballooning out of the
sleeve causing damage to the tube and the sleeve.
This is not covered under the warranty.
10. Peg out the Reflective Endurance
Storm Straps for extra stability. Please
make sure in heavier weather you use all
the guy lines and storm straps to hold
the awning in place.
11. Finally, locate the eyebrow canopy.
Remove the grey adaptor from the
included hand pump and use the smaller
grey nozzle the inflate this tube.
