23
3. Slide one of the spit forks onto the spit rod
and tighten its thumb screw to secure it into
place. Insert the pointed end of the spit rod
into the meat being cooked and slide the
meat towards the centre of the rod. Make
sure the fork is fully into the meat. Slide the
other fork onto the rod, into the meat, and
tighten the thumb screw once in place. For
optimal rotisserie cooking, food must be
placed securely onto the middle of the spit
rod and balanced so that the rotisserie can
rotate freely without interference from any
barbecue surfaces. Any loose sections of
meat should be secured so they do not
hang down and interfere with the rotation of
the spit rod. Do not overload the rotisserie.
A chicken or joint of meat of approximately
2kg should be the maximum.
4. Insert the pointed end of the spit rod into
the motor. Lay the other end of the spit rod
onto the opposite bracket.
5. Light the grill as specified in your
barbecue‘s instructions.
6. Turn on the rotisserie motor to begin
rotisserie cooking. The hood has been
designed so that it may be closed during
rotisserie cooking.
7. Always cook foods on the lowest flame
setting to avoid burning or overcooking.
8.10. Flare-Up Control
*** Very Important Notice ***
Flare-ups occur when meat is barbecued, and
its fat and juices fall upon the hot flame tamer /
lava rock. Smoke of course helps give food its
barbecued flavour, but it is best to avoid
excessive flare-up to prevent food being
burned. To control flare-ups, it is
ABSOLUTELY ESSENTIAL
to trim away
excess fat from meat and poultry before grilling,
use cooking sauces and marinades sparingly
and try to avoid very cheap cuts of meat or
meat products as these tend to have a high fat
and water content. Also, the burners should
always be placed on the low setting during
cooking.
When flare-ups do occur, they can usually be
extinguished by applying baking soda or salt
directly onto the flame tamer / lava rock. Always
protect your hands when handling anything
near the cooking surface of the barbecue and
take care to protect yourself from the flames.
If a fat fire occurs, please see the instructions
given below.
8.11. Fat Fires
Empty and clean the drip tray and drip pan (and
foil liner, if applicable) of food debris after each
cooking session. If the barbecue is to be used
for large gatherings, it will be necessary to turn
off and cool the barbecue every two hours to
remove food debris from the drip tray and drip
pan (and foil liner, if applicable), and clean it out.
The time between cleaning may need to be
reduced if very fatty foods or cheap meat
products are being cooked. Failure to do this
may result in a fat fire, which may cause injury
and could seriously damage the barbecue.
In the event of a fat fire:
If safe to do so, turn all control knobs to the
‗off‘ position.
Turn off the gas supply at the gas bottle.
Keep everyone at a safe distance from the
barbecue and wait until the fire has burnt
out.
Do not close the hood or lid of the barbecue.
NEVER DOUSE A BARBECUE WITH
WATER. IF AN EXTINGUISHER IS USED,
IT SHOULD BE A POWDER TYPE.
DO NOT REMOVE THE DRIP TRAY.
If the fire does not seem to be abating or
appears to be worsening, contact your local
Fire Brigade for assistance.
8.12. End of Cooking Session
After each cooking session, turn the barbecue
burners to the ―high‖ position and burn for 5
minutes. This procedure will burn off cooking
residue, thus making cleaning easier. Make
sure the hood or lid is open during this process.
8.13. Turning Off Your Barbecue
When you have finished using your barbecue,
turn all the control valves fully clockwise to the
―Off‖ position, then switch off the gas supply at
the bottle.
Wait until the barbecue is sufficiently cool
before closing its hood.
9. Care and Maintenance
Regularly clean your barbecue between uses
and especially after extended periods of
storage. Ensure the barbecue and its
components are sufficiently cool before
cleaning. Do not leave the barbecue exposed to
outside weather conditions or stored in damp,
