Outback Power Systems FLEXware 500, User Manual

Page: 14 / 24

Plastic bushing,
DC side
Figure 11: DCA bushing
Note: The DCA will be held firmly in place when the DCC (FX cover) is secured at the end of the
installation.
To install an ACA:
• Follow the separate ACA instructions for mounting to the FX.
• Line each ACA up with its conduit hole in the AC chassis.
• When aligned, move the AC chassis snug against the ACAs after the ACA installations.
• Press a 1” plastic bushing from inside the AC chassis out to the ACA through each previously
removed knockout, sliding the AC chassis against the ACAs until snug.
• Install two M5 X 25mm screws (provided in ACA hardware kit) in each ACA and tighten securely.
11